• Designed for machining high alloy or hardened steels, cast iron, tool steel with .045 carbon content or greater, hard “6 and 9 shaped” chips, or hard fine / granular chips which are highly abrasive
  • Heavy duty metal chain guard for robust protection
  • Abrasion resistant steel used for conveyor belt tracking and belt skirting in the lower curve of the conveyor
  • Heavier gage incline cover plates with more robust fasteners to secure the cover plate
  • Induction hardened belt connecting pins (axles)
  • Belt apron plate hinge loop opening welded for more strength
  • Special “inverted V” carrying cleats on belt so tough chips don’t hang onto the cleats at discharge of the conveyor
  • Two durable copper wire cleats to keep the inside of the conveyor clean
  • Two serrated edge cleats to effectively remove tough long stringy chips
  • Hardened hubs where the belt turns around in the tail end of the conveyor – normally a high wear area
  • 3 types of design configurations
  • Integral Tank
    • High Pressure coolant system
    • Pumps/ plumbing/coolant transfer
    • Downstream Filtration
    • Tramp oil skimmers
    • Coolant Chillers/heat exchangers
  • Complete electronics/UVS-Ecologic controls with Jam Manager® for the ultimate in conveyor control
ISO 9001 Certified Jorgensen Conveyors is a member of AMT Jorgensen Conveyors is a member of CEMA Jorgensen Conveyors is a member of Metropolitan Milwaukee Association of Commerce Jorgensen Conveyors is a member of the National Association of Manufacturers